Has anyone installed the flush gas cap

[Baalz]

Yeah like any rub I accessorize.
Looking for tips on installing an H-D flush mount gas cap/gauge in an EFI softail.

The chrome ring has two sided tape on the filler side. Was thinking it may be better if I removed the tape and siliconed it in place instead.

Any pointers on the gauge side?

[Fireberry]

I had them on my FLSTFI. I think they are really good looking. On the gauge side never a problem. On the filler side I lost two of them. The guys in the shop used silicon to finally get it to stay in place.

[TXCHOP]

Silicone may not be a bad idea, but be carefull of the ooze....yup ooooze..Dont use to much or it may be hard to clean off good. The nice part of the kit is that H-d sells the rings separately.

[Chuck K.]

I have the kukyan (S/P?) LED fuel gauge and flush mount gas cap.. Like it so far was really easy to install.. I would not use silicone rubber unless it is the special type compatible with gasolene.. Your normal RTV silicone will swell to 2 or 3 times its original size once it comes in contact with gasoline.. Then it does a real nice job of plugging up your fuel lines, dont ask me how I know, just sayin.... :coffee: