proximity key code
2008 sportster sat too long and battery ran out, prolly needs a new one. Charged it up with trickle battery tender. Lights and horns are just fine but it acts dead when the RF key is inserted and turned. Anti-theft lights start flashing. Do I have to get it to the dealer for new coding?
|
Try manually entering your code with the turn signal switches.
Owner's manual may be able to help you here. |
Did you check the battery in the key fob?
|
I would check the tire pressure too.
|
Does it have a PATS (chip in key) or key fob thingy?
If fob probably needs new battery. Technology is a wunderfull thing! |
Bought the bike used. No manual, only 1 RF gizmo but 2 keys. It is not a "keyless" bike.
|
Some say the default code is the last 5 digits of the vin. |
Shorter version of the same thing.......
|
You just need to reprogram the tssm to the fob after you reset alarm manually. Just went through this not to long ago.
On-off-on-off. Then some turn signal sequences while you wait for turn signal flashes etc until the fob syncs with the tssm. I'll find it in the manual and post it up. |
Table 3-3. TSSM Key Fob Assignment
NO. ACTION WAIT FOR CONFIRMATION NOTES 1 Set RUN/OFF switch to OFF Verify that security lamp is not blinking (vehicle is dis- armed) This assignment procedure must be completed with no pauses between steps greater than 10 seconds 2 Turn IGN switch ON-OFF-ON-OFF-ON 3 Press left turn switch 2 times and release 1-3 flashes turn signals & indicators depending on vehicle configuration (See Section 3.3 TSM/TSSM VEHICLE DELIVERY regarding battery discon- nects.) 1 flash-Worldwide TSM, no security 2 flashes-North American/ Domestic configuration TSSM 3 flashes-European/HDI configuration TSSM 4 Press right turn switch 1 time and release 1 flash turn signals & indicators 5 Press left turn switch 1 time and release 2 flashes turn signals & indicators 6 Press and hold key fob button until confirmation is received 2 flashes turn signals & indicators This may take 10-25 sec- onds 7 If you have two key fobs, press and hold button on second key fob until confirmation is received 2 flashes turn signals & indicators optional step 8 Turn IGN switch OFF |
So it does have the security fob thingy (proximity transmitter)?
|
Thanx, guys, I didn't even know where to start on this. I googled Harley TSSM and a bunch of references came up. I'm gonna read everything before I start doing this. I'm not sure the key fob has a button.
|
My key fob doesn't have a button. It just needs to be close to the bike for the bike to start. I still say check the battery in the key fob if you haven't already.
|
Quote:
|
Quote:
I'm not sure about that. How many miles are on it? I think I'd go with the air first, then the battery and maybe wash it. Then if it makes noise maybe switch. Thoughts? Sent from my iPhone using Tapatalk |
All times are GMT -5. The time now is 02:35 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ©2006 - 2020 doofclenas.com, LLC
The Doof Clenas 43 logo is a registered trademark of doofclenas.com, LLC