#31
|
||||
|
||||
A tool box full of tools and what don't I have....12 point 1/4" and 10mm sockets. It required I go for a ride. Now I have the tools, and the pads, and the advice. I'm out of excuses...sooner of later I'm gonna have to tackle this job.
__________________
Dan '08 Ultra S&S SPO's |
#32
|
|||
|
|||
getherdone Dan>getherdone
|
#33
|
||||
|
||||
I suggest when you are at Sears, to pick up a 1/4" 12 point 3/8" drive socket, as those little 1/4" pins are tight. I have stripped out 1/4" 12 point 1/4" drive sockets before. Use masking tape on your fender, and the surrounding area to protect from scratches. GIT-R-DONE!
Thorns
__________________
On this lonely road, trying to make it home, doing it by my lonesome-pissed off, who wants some? "The right of the people to keep and bear arms." "Gimme back, gimme back my bullets" |
#34
|
||||
|
||||
Brake job update...
I haven't done it yet. But I did make an appointment to get a new rear tire installed.
C'mon, its a step in the right direction.
__________________
Dan '08 Ultra S&S SPO's |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2011 FLHX | ms_tapestry | Touring Discussion | 105 | 06-01-2011 07:27 AM |
09 FLHX turn signal problem | BigSwede | Electrical Systems & Diagnostics | 20 | 10-01-2009 12:14 PM |
WTB: Stock seat for a FLHX | Serg06 | Item Wanted | 22 | 07-22-2009 12:24 AM |
E-Z Brake | 16X9 Shooter | Accessories | 20 | 01-07-2008 06:59 PM |