#1
|
||||
|
||||
Detachable docking point question
Does anyone know the size of the nylon washers located on the docking points that receive the detachable TourPak rack? My TourPak has gotten a little loose on the mounts and it needs re-snugged.
Harley shop sells the OE washers, and the full set is 40 fricken dollars. I didn't stick around to ask about specs. Thanks for any help anyone can offer. May just need to ride over to the hardware store and look around.
__________________
Chris Quarenta-tres . . . |
#2
|
||||
|
||||
Are you working tomorrow??
I'm going to try and get a ride in probably after 11 am. Destination yet unknown. Might head south and west other side of C'ville.
__________________
Kimber |
#3
|
||||
|
||||
Best I've found is to just buy the ones from HD.
I found a guy making aluminum ones over at anther HD forum, they lasted longer, but eventually wore and had to be rotated. I need to go back and replace them again. Tour packs been off for a few months cause I despise going and paying for them again.
__________________
<a href="http://www.mytriplogs.com" target="_blank"> <img src="http://www.mytriplogs.com/sigs/mtl_create_us_states_map.php?rz=75&vu=vuuvuuuu uuuuuvvvvvvuvuuuvvuuuuvvuvuvvuvuvuvvuuvuvuu" border="0"></img> <br>Free, personalized travel maps at mytriplogs.com</a> <br> </center> |
#4
|
||||
|
||||
Quote:
Been looking at some good solutions for the detachable point wear on those bushings - I'm gonna go the simplest route first, and just rotate the bushings and add a couple layers of black electrical tape to 'em to snug things up.
__________________
Chris Quarenta-tres . . . |
#5
|
||||
|
||||
I can't think of a better solution than the hd ones, its one of the main reasons I got an ultra to permanently mount the tour pack, the rattling drove me "more" nuts
__________________
BAAAA BAAA BAAA "Blame Russ in 2012" "Can We Still Blame Russ in 2013" who's to blame in 2014? OH THIS IS SO NOODLES FAULT Chitty Chitty |
#6
|
||||
|
||||
I only normally take mine off for a few weeks in the summer, but dang I hate to give that up and go back to the permanent mount. Rattling is annoying for sure.
__________________
<a href="http://www.mytriplogs.com" target="_blank"> <img src="http://www.mytriplogs.com/sigs/mtl_create_us_states_map.php?rz=75&vu=vuuvuuuu uuuuuvvvvvvuvuuuvvuuuuvvuvuvvuvuvuvvuuvuvuu" border="0"></img> <br>Free, personalized travel maps at mytriplogs.com</a> <br> </center> |
#7
|
||||
|
||||
Quote:
You got my number I think.
__________________
Kimber |
#8
|
||||
|
||||
I went the hardware store route, worked good so far. Its been about a year. Two fity for both rubber grommets. I'm cheap.
__________________
Now that I'm older I thought it was great that I seemed to have more patience. Turns out, I just don't give a shite!
|
|
|